应吕广宏老师邀请,著名核材料学家Oak Ridge的Roger Stoller研究员将于10月21日(周三)来我院做学术报告。
题 目:Prospects and Contributions of Multi-scale Modeling to Fusion Reactor Materials
------------------------------
Brief CV of Roger Stoller
Roger E. Stoller, Ph.D., is a distinguished research staff member and the program manager for fusion reactor materials in the Materials Science and Technology Division of the Oak Ridge National Laboratory in Oak Ridge, Tenn. He is a co-principle investigator for the ORNL Energy Frontier Research Center on Defect Physics that was funded in 2009 by the U.S. Department of Energy’s Office of Basic Energy Sciences that will be employing a range of advanced computational and experimental methods to elucidate the fundamental behavior of radiation-induced defects in structural materials.
Prior to his arrival at Oak Ridge National Lab in 1984, Stoller served as a research associate at the University of California, Santa Barbara, for four years and as a staff engineer at General Electric in Sunnyvale, Calif. Stoller is currently an adjunct professor of nuclear engineering at the University of Michigan, Ann Arbor. He is the author or co-author of more than 100 publications and reports on the effects of radiation on materials in environments that include light water and fast breeder reactors as well as fusion reactors.
Stoller earned B.S. and M.S. degrees in nuclear engineering from the University of California, Santa Barbara, and the University of Wisconsin, Madison, respectively. In 1987, he earned a Ph.D. in chemical engineering from the University of California, Santa Barbara.
Since 1986, Stoller has been an active member of ASTM Committee E10 on Nuclear Technology and Applications, contributing to standards development in that committee, holding subcommittee offices and serving as E10 chairman from 2002-2007. Twice he received the E10 Award of Appreciation, in 1988 and 1990; in 1995, he received the Award of Merit from the committee. He has been actively involved in the success of the ASTM Symposia on the Effects of Radiation on Materials, which is sponsored by Committee E10, serving as symposium chairman, co-chairman, presenter and author. He is also a member of ASTM Committee C26 on Nuclear Fuel Cycle.
A member of the ASTM Committee on Publications from 1993-2003, Stoller held the positions of vice chairman and chairman. He has served on the ASTM Board of Directors since 2004, was chairman of the Finance and Audit Committee in 2007, and is currently the First Vice-chairman of the Board of Directors.
In addition to ASTM International, Stoller is a member of the American Nuclear Society, where he is a former chairman of the Fusion Energy Division, ASM International and the Materials Research Society. He was named a fellow of ASM International in 2007 and of the American Nuclear Society in 2009.